EASA issues emergency AD on life limits of A330 and A340 landing gear parts

The European Aviation Safety Authority (EASA) issued an emergency Airworthiness Directive (AD) effecting specific Airbus A330 and A340-200/-300 aeroplanes. EASA requires reduction of the existing main landing gear (MLG) bogie beam life limits and replacement of each MLG bogie beam that has already exceeded the new limit.

During ground load test cycles on an A340-600 aeroplane, the MLG bogie beam prematurely fractured.
The results of the investigation identified that this premature fracture was due to high tensile standing stress, resulting from dry fit axle assembly method.
Improvement has been introduced subsequently with a grease fit axle assembly method.
Analysis was performed on other bogie beam with dry fit axles. It has been determined that MLG bogie beams with specific part numbers  are more likely to suffer from standing stress generated by dry-fit axles because these bogie beams are stiffer between the axle sockets. These two part numbers are fitted on A330, A340-200 and -300 series aircraft.

Fracture of a MLG bogie beam under high speed could ultimately result in the aeroplane departing the runway, or in the bogie detaching from the aeroplane, or MLG collapse, which could cause structural damage to the aeroplane and injury to the occupants.

More information:

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: